New flasher problem

Xslickcafe81

XS400 Member
Messages
13
Reaction score
0
Points
1
Location
Gerrardstown, WV
Ok after buying 3 different relays I finally got the right one today. Now the problem is all 4 blinkers flash at the same time. It doesn't matter if the switch is in the left or right position. Anyone else run into this?:wtf:
 
One thing I forgot to mention. Before I installed the electronic relay all of the blinkers would light up solid with the factory relay and led flashers. They didn't flash.
 
1. Put stock flasher back on.
2. Buy four 10 watt, 10 ohm resistors (about $4)
3. Add one pair of resistors in parallel from the colored/striped wire to the ground wire on each of the rear signals. You can test the connection before permanently splicing.
4. Signal away like a maniac.

If this isn't enough resistance try a single resistor instead of a pair in parallel.
 
I don't think you need a new relay; you need a new flasher or resistors. I have had the most success with resistors and they are cheaper.
 
Back
Top