For Sale - Parting out a 1983 Maxim 400

wirehairs

XS400 Addict
Messages
107
Reaction score
1
Points
18
Location
Fridley, MN
The frame is gone by I still have most of the parts and the engine, that has been opened up. The starter isn't available, only because I bought the kit to replace the brushes and it has been taken apart. I don't have the painted side covers. I have the tank, but I can't find the key.

Please email me your want list! Located in St. Paul, MN
 
The frame is gone by I still have most of the parts and the engine, that has been opened up. The starter isn't available, only because I bought the kit to replace the brushes and it has been taken apart. I don't have the painted side covers. I have the tank, but I can't find the key.

Please email me your want list! Located in St. Paul, MN

Left and right side panels available?
 
Just the one shown in the top right of this picture.
Trunk of parts.jpg
 
I'm looking for a replacement tank for a 1982 XS400 Seca and I think the 1983 tank would work. Is it possible to get the gas cap off without the key? And how rusty is it?
 
I'm looking for a replacement tank for a 1982 XS400 Seca and I think the 1983 tank would work. Is it possible to get the gas cap off without the key? And how rusty is it?
Just so this board knows, I did send Alex the tank, plus the airbox cover, plus the petcock.
 
It’s inside crankcase cover and looks like this pic

Well, I don't have good news Carter. I've been unable to remove the screws holding that crankcase cover down. I got two out, put on some penetrating oil, and used an impact driver, but they just wouldn't budge. When I really forced it, a couple of screw heads stripped. So that's the end of it in my book. If you know anyone in St. Paul who wants to come try it, they are welcome to the whole motor for free. :-(
 
This is from the main wiring harness, coming from the main fuse to ignition and whatnot. Can try to get a better photo later, i just need a male and female end with at least 6 slots i believe
 
Back
Top