one carb was alot dirtier than the other, which is normal. I will be replacing parts needed to rejet and recalibrate. When the carbs finish boiling al
tail lights are on and i have an evtension piece of wire that runs in the fender to the wire harness.
I put all of the controlls back together and started to see how to route everything. I noticed that it has 21977 on it and if i can get it to roll out
the front end is all put together, torqued and set just as the manual says. I ave the front tire off the ground and when the steering is centered i ca
one carb was alot dirtier than the other, which is normal. I will be replacing parts needed to rejet and recalibrate. When the carbs finish boiling al
i seperated parts as they would have to get bagged and labelled once they were cleaned, the bad wold have to have a good seal or they may as well be c
I took both carbs completley apart and seperated metal that i can clean with carb cleaner and what I can boil, and what will have to be cleaned with o
this is the top of the carbs, there were a few stripped bolts that will be easy enough to replace. All part of the program if we want to see what kind
TimmyT

one carb was alot dirtier than the other, which is normal. I will be replacing parts needed to rejet and recalibrate. When the carbs finish boiling al

There are no comments to display.

Media information

Album
1978 Yamaha XS400
Added by
TimmyT
Date added
View count
2,260
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top