Recent content by Robj

Thanks man!

looks sharp I like it.

I worked on the tank shape and paint for fun, I changed the shape with some bondo to give it some hard lines, I like how it turned out. Not sure about the 'rat-rod' paint job on the tank, I might go to just a Grey or Black, but it was fun not really a priority just something fun to mess around...

Fuse box looks good, thats one thing I need to do to my bike.

Hey thanks for all the advice and input so far, its the beautiful thing about forums is the advice is saved for later prospecting. Well I'm alive and so is my bike, had to do a mad rebuild on the motor so I did not get to check the piston ring but they looked good, I also looked inside the the...

I like the looks of it.

Exams done for the summer. Now back to the Bike. :) I have cleaned up the jugs and the motor exterior some more. I removed the head-gasket by carfully scraping it off and then using 300 grit wet sand paper to lightly sand and completely clean the surface. The head-gasket was leaking. It...

Im sleepy reading this thread so forgive me if i got this wrong. The run switch wire does just end because its ground is the handle bar.The wire goes into the housing attaches to a plate. When the start button is pushed in it touches the plate and complets the ground throught the handle bar...

I would be careful around plastic because it's parolium based too. But I'm sure it's ok if you wash the stuff off quickly, or better yet just test it on a small area first.

Hey man, welcome! Wow that tank looks really clean! So I was cleaning muck and oil off my engine block the other day and I tried lots of different products. I used break cleaner, foam cleaner, liquid wrench,WD-40, soap. I even tried DIY soda blasting. dont waste your time with any of those...

That seat looks cool I dig it, It works with the tanks curves.

Nice looking bike, your working fast :thumbsup:

Nice work Greasey! look sexy clean.

Hey, So I finally had some time in-between studying for exams, so I did some work on the old motor.I also got my Gasket set so im excited :). Wow did that ever take a lot of work to get the timing chain off! My motor would not rotate 360 because of crap on the Cylinders The cylinders...

Hello from Victoria!