Recent content by trzcina2

  1. T

    My XS 400 Cafe Racer Project

    Hello, thank you! But anyone can help with my question? Is it possible to use Rectifier/Regulator combo on SOHC engines? My lights are getting brighter when Im opening throttle, and dimmer on idle.
  2. T

    My XS 400 Cafe Racer Project

    Hello everyone! Its been a while since my last login here :) My xs400 still running fine and i use it on daily basis when weather is great. Some time ago, while i was fueling my bike, some guy asked me: "Hey do you want some pro photos of your bike?" i said yeah sure! So here are some photos...
  3. T

    Clutch Basket and drive gear play

    Hello Everyone! It's been a while since my last post... However i noticed strange sound from right part of engine near clutch and decided to take right cover apart. What i found was a bit surprising so it is time to ask you guys for advice. 1. My clutch basket and sprocket behind it has a LOT...
  4. T

    '80 XS400 whiteout

    Whoa.... That's look simply amazing :)
  5. T

    My XS 400 Cafe Racer Project

    Still fighting with carbs but..... MY SPOKE WHEELS ARE FINALLY DONE!!! It took over 6 months to get them finished but damn... it was worth waiting!!!
  6. T

    My XS 400 Cafe Racer Project

    I don't remember... I tried different settings around 3 turns out, but i don't remember current position.
  7. T

    My XS 400 Cafe Racer Project

    Tried that. No big difference :) Bike was a bit easier to start but, lacked power on high rpms and after it warmed up, idling was poor and sometimes it died. I'll try Sandrew's setup without any foam :) and let you know! I'll also try new carb setup with H-pipe and also let you know :D Keep...
  8. T

    My XS 400 Cafe Racer Project

    Thanks, That's great! I'm wondering what needles on the highest position means. Highest means rich mixture or lean mixture?
  9. T

    My XS 400 Cafe Racer Project

    Thanks. These are original K&N filters. They cost a LOT so i'm trying to get them work properly no matter what :)
  10. T

    My XS 400 Cafe Racer Project

    Hi! I still have some issues with carbs and still need some help :) In this gallery (link below) you can see what i was trying to do with my POD filters. I bought universal air filter material, cut it in circles to mach internal size of K&N POD filter put them in and secured them with rubber...
  11. T

    My XS 400 Cafe Racer Project

    Oil is in normal level. Engine is running fine. Idles rather good. On the video i switch off the engine so you can see that the gauge is starting to lit. Cheers!
  12. T

    My XS 400 Cafe Racer Project

    Guys! I need help! Again... After running bike in rain i noticed that my oil gauge started to show dimly light while bike was running. I immediately switched off the engine... and then oil gauge started to lit very brightly... What do you think? Is this caused by rain and oil pressure sensor...
  13. T

    My XS 400 Cafe Racer Project

    Ok, thanks! I'll make "stacks" as you did and we will see if this will save my problems.
  14. T

    My XS 400 Cafe Racer Project

    I'm using Pilot: 45 main 137,5 Needle: stock float: 26,6mm Thanks for any advice :)
  15. T

    My XS 400 Cafe Racer Project

    That's interesting... i thought, that with big pod filters, i have to much air and the mixture is too lean when i open the throttle rather than too rich. My mixture screws are 3,5 turns out and if i screw them in about 1 turn, it starts popping from mufflers. My spark plug looks like this after...
Back
Top