WelderDave
XS400 Addict
So I took the original ball bearings out and I was looking at the races. Those look pressed in. do they also need to come off?
-
Enjoy XS400.com? Consider making a donation to help support the site.
XS400.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
Tapered steering bearings
- Thread starter WelderDave
- Start date
Gra900
XS400 Addict
If you’re planning on changing to taper roller, yes the old bearing cups have to come out. A bit of heat and a long brass drift and 2 lb hammer will help
WelderDave
XS400 Addict
If that’s the case I’m wondering if I should just cut them and make it real easy. Heat would destroy the rubber seal anyway. The frame is also in powder coat too so I’d rather not potentially wreck the paint with heat
