Search results

Hi. Yes, but for now only spacers for the front axle. Spacers for a (new) break disc will also be required. Rest is pretty much "standard" swap from 2005 RS 125.

And so the story goes (slowly...) Engine_2 by kryst posted Jan 18, 2017 at 3:37 AMDSC01918 by kryst posted Jan 18, 2017 at 3:37 AMDSC01909 by kryst posted Jan 18, 2017 at 3:37 AMDSC01898 by kryst posted Jan 18, 2017 at 3:37 AMDSC01903 by kryst posted Jan 18, 2017 at 3:37 AM

Thx :)

Very simple - I bouth a thin plywood (1,2 mm). It bends easily without breaking. Then I cut a shape that remotely reassembled seat, about 8 times. And one by one (one a day!) I glued it together, fixing it to the frame with bar clamps. When dried, it holds shape perfectly. Took about a week in...

Hi! Its been a while since last update, personal stuff, but the project is not dead. Have a look :) RS front with KTM risers is on - fits like a charm (thanks LuckyEight!) - front wheel is not done yet, needs some spacers. Rear will go higher, sits a bit too low for my taste... Finally, it is...

I already have and the seller is willing to send a replacement. That is actually great with them. Not sure if I want those shocks on my bike though...

They have a mounting bracket welded on, just not drilled. I will mount the exhaust underneath the footpegs - and there are unused mounting points left after removing the central stand. Should work just fine. And thanks for the tip about replacing the material! Second small update: I...

Hi! it has been awhile, but the XS project is still alive :) Not much has happened though. Work killed my free time, personal life killed my will to do anything :) But - i finally ordered shocks from China, and they came. Hard to say what they are actually worth, but the look the part. The...

just one of gazillion factory options :)

Shaping is pretty much done :] The front (where a hole for a screw is) will be cut an inch or two and rounded, but for now I need it to line the seat properly (mounting points still need to be done).

Clip-ons... Flipped bars look like the builder was a skinflint :)

It has been awhile, since my job let me come back to my XS (the bare frame became a bit ginger here and there..), but i'm at it again :) I figured out (captain obvious :)) that I have to get all the mounting points I might possibly need to proceed with next bits. So I need something to mount...

...and the rear is done! :)

Nope :) I'll have to figure out how to mount a seat (and make a base for it) before painting the frame, so i'll get to it rather sooner then later :)