Search results

Well, I guess I should look at this as a learning experience... I'll go ahead and get the gasket. Is there anything specific I should look for when I get in there? A previous poster mentioned dogs. Thanks for your help everyone. I'll likely update this thread when I get in there and look...

Sorry, I double-checked and did use 20w-50 on the last oil change. My mistake. The chain and sprockets seem fine. I've measured the chain for slack and the sprocket teeth aren't worn. I went back and adjusted the clutch again - also replaced the clutch pushrod seal because of a slow leak...

I'm using Yamalube 15w-40. Thanks for the input guys. I'll definitely make sure the clutch is properly adjusted and for wear. Is there a trick to adjusting the clutch at the engine? I turn the adjustment screw in until I feel resistance, then back it out 1\4 of a turn. Is there a better way...

Hey all... I've got a 1980 XS400g that I've been restoring to running condition. This is my first bike so I'm kind of learning as I go. I had the engine running perfect, but now I've run into a transmission problem... A few days ago, I went to accelerate from a full stop on an incline...

Hey everyone. I'm getting an '80 XS400 Special II back road worthy after it apparently went down at some point. Everything is going well, however I'm having a little trouble locating some front brake hardware for this bike, which has both front and rear drum brakes. Most of the parts on...

Vacuum leak? Air could be getting sucked in through a loose carb or airbox clamp.