Search results

Sounds good, thanks Chris.

Down below where it says "Post Reply" there should be a button that says "Upload an Image or File". After the file is uploaded you can click "Thumbnail" or "Full Image" to insert the picture where your cursor is.

Just a thought, I had a similar issue because one of the vacuum ports on the boots where the carbs mount to the engine wasn't plugged. Make sure those are sealed or else your air-fuel mix will be all messed up in that cylinder.

Assuming that the 27 watts is important to the function of the relay, I believe that the installation of a resistor in parallel with the blinkers would work. Someone else may be able to tell you whether or not the power drawn by the LED's is a factor, but I think the following would increase the...

I recently did some work on the wiring harness of my bike and when I put the coil on I plugged the [red/white and orange] plug into the right coil and the [red/white and grey] plug into the left coil as per a wiring diagram I was using as well as a post on here by xschris. Upon turning over the...

Turns out the White-Green wire going to the plug was compromised and I replaced it with a blade style plug and it seems to be working. Might replace the plug at some point if I can find one.

I got the valves set and finished cleaning things up down by the clutch. I replaced the old fuse box with a homemade 3D printed one and it seems to be working well. While I was working with the electronics I removed the harness and cleaned things up and re-taped some sections. After I got...

Thanks Chris. I will take a look at those floats again today. I was using the "Haynes XS400" service manual and set the floats and jets according to that. I noticed that the supplemental manual for the "XS 400 H, SH" had some discrepancies so I will use that on going forward. Thanks for the...

I have answered my own question about taking off the left cover with a great post from Drewcifer. http://www.xs400.com/threads/rewiring-stator-and-regulator-swap.7616/#post-79878 I should be able to follow the wires through the muddy mess underneath and find the connector and disconnect and...

I recently have started working on my uncle's/dad's XS400, my first motorcycle project. I have worked with QT50's and other small mopeds in the past, but nothing this size. The bike hasn't been ridden seriously since the '90s as far as I know, although it has ran a few times since then. Today I...