volcomskater77

XS400 Chopophile
Top Contributor
Messages
1,198
Reaction score
4
Points
38
Location
tinley park, Illinois
Hey y'all, so my buddy and I were doing the exhaust on my chop last night and started talking about front end swap options for his CB700sc. Got me thinking about wheel options for mine, so I started digging into 19" 7 spoke mags on the front of my chop. I'll be going with the 80-81 xs850 front for uniformity with my 16" mag rear, but I found that an 80-82 kz1000 LTD used the same axle diameter (14mm).

Well I just so happen to have that complete dual disc front end in the shed left over from a part-out. So I tossed that front wheel the dirt tracker snow-roller project with stock (rebuilt a few years back) length forks.

20200426_124051.jpg

Excuse the haggard "proof of concept" exhaust.

20200426_124008.jpg

Throttle side spacer is stock kz1000

20200426_124028.jpg


Clutch side is something I had laying around. Its not perfect, hence the offset.
The wheel has an electronic speedo, and has a male stud on the "centering" part of the speedo. Rotor engagement could be better, but you can make anything work with enough math and fab work

20200426_124032.jpg


20200426_124024.jpg

19" kz1000 7 spoke front
18" xs400 7 spoke disc rear wrapped in 5.10×18 Kinda 244.
20200426_123959.jpg
 
Back
Top