1. Dismiss Notice
  2. Hey Facebook people... We've created a group for XS400.com members to connect. Check it out!
    Dismiss Notice
  3. Want an XS400.com t-shirt? Go to the store to order. Limited sizes and quantities available.
    Dismiss Notice

For Sale - Parting out a 1983 Maxim 400

Discussion in 'Classifieds' started by wirehairs, Jun 6, 2020.

  1. wirehairs

    wirehairs XS400 Addict

    The frame is gone by I still have most of the parts and the engine, that has been opened up. The starter isn't available, only because I bought the kit to replace the brushes and it has been taken apart. I don't have the painted side covers. I have the tank, but I can't find the key.

    Please email me your want list! Located in St. Paul, MN
     
  2. John-Paul

    John-Paul XS400 Member

    Hey, you got the caps from the side of the frame?
     
  3. wirehairs

    wirehairs XS400 Addict

    No - those went with the frame.
     
  4. robvill

    robvill XS400 New Member

    Left and right side panels available?
     
  5. wirehairs

    wirehairs XS400 Addict

    Just the one shown in the top right of this picture. Trunk of parts.jpg
     
  6. Italianzero

    Italianzero XS400 Member

    Do you have the front end?
     
  7. AlexH

    AlexH XS400 New Member

    I'm looking for a replacement tank for a 1982 XS400 Seca and I think the 1983 tank would work. Is it possible to get the gas cap off without the key? And how rusty is it?
     
  8. Carter Thomas

    Carter Thomas XS400 Member

    You have the pickup coil / governor?
     
  9. wirehairs

    wirehairs XS400 Addict

    I think so. Can you point me towards a picture of them?
     
  10. wirehairs

    wirehairs XS400 Addict

    Just so this board knows, I did send Alex the tank, plus the airbox cover, plus the petcock.
     
  11. Carter Thomas

    Carter Thomas XS400 Member

    It’s inside crankcase cover and looks like this pic
     

    Attached Files:

  12. wirehairs

    wirehairs XS400 Addict

    Well, I don't have good news Carter. I've been unable to remove the screws holding that crankcase cover down. I got two out, put on some penetrating oil, and used an impact driver, but they just wouldn't budge. When I really forced it, a couple of screw heads stripped. So that's the end of it in my book. If you know anyone in St. Paul who wants to come try it, they are welcome to the whole motor for free. :-(
     
  13. Carter Thomas

    Carter Thomas XS400 Member

    Well that stinks. Might be able to drill em out. Had to do that on a 750 maxim I had
     
  14. Jsn44

    Jsn44 XS400 New Member

    2
    0
    1
    Canada
    Do you still have the front brake caliper? I'm searching for that and the side panels.
     
  15. wirehairs

    wirehairs XS400 Addict

    No, sorry. Those are gone.
     

Share This Page