step up tolerance

imagine and chop

XS400 New Member
Messages
3
Reaction score
0
Points
1
Location
new york
hey everyone.
im lookin to hardtail my bike. im going from the two bottom frame rails under the engine and the 1.25 in backbone. im gunna slug/sleeve the backbone and use 1.25 in tubing for the hardtail (dom). the questions, what is an acceptable slip fit tolerance for stepping up from the .975 od frame rail to an intermediate tube that then slips into the 1.25 od hardtail. i have some ideas about it but id like to see some uninfluenced ideas. i havent read alot of responces to questions on this forum so i dont know how people respond to multiple questions, good or bad. thanks and respect.
 
Back
Top