1. Harness. When rebuilding a harness, start by placing the old harness on a board to make a harness jig. Use a few 4 inch nails to mark all the branc
The Amp/Tyco sockets I used
2. Mark each connector with a number to identify it. Mark the board with a line to indicate the branch length. On your schematic, indicate the connect
New starter cables. I used some epoxy and mil spec lugs from work.
1. Harness. When rebuilding a harness, start by placing the old harness on a board to make a harness jig. Use a few 4 inch nails to mark all the branc
Schematic used. This was posted on xs400.com a few weeks ago. I had to modify it to work on my bike. The changes were located around the fuse holder a
gbyamaha

1. Harness. When rebuilding a harness, start by placing the old harness on a board to make a harness jig. Use a few 4 inch nails to mark all the branc

There are no comments to display.

Media information

Album
1979 xs400 (xs250) harness rebuild
Added by
gbyamaha
Date added
View count
1,685
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top