Recent content by carlxs400

I will make sure I post lots of pictures when I am doing it. Yeah I am going to order the whole kit with the tubing and axle plates. Just never done it and nervous hahaha. Sorry wasnt aware I could edit my posts, thanks for the heads up, still new to the forums. Did your buddy make 2 bends on...

sorry not get rid of it? is it a good thing or a bad thing? I was going to get rid of the hoses and bend in stainless steel tubing.

as well I wanted to ask about your hardtail, did you use a kit from travis and how did you connect it to the backbone section?

yeah it does have an oil cooler. Can I get rid of it?

you end up using that rear fender? if not wanna sell it?

that bike was bad ass, let me know when you have stuff going, easier to get some stuff from Canada. Do you have any left overs?

How much do you want for the 400 carbs?

hey hows it going? I am looking for a full set of carbs for an 81, happen to have anything laying around?

somewhere under 100. you got something for me??

do you still need one? I replaced with an aftermarket.

as well looking for a bobber solo seat, with or without springs.

looking for cheap handlebars, preferably zbars, but something along that style will do.

perfect thank you, now next question. Can I put the 52mm xs650 filters on instead of the 48mm and these should fit over the stock 400 carb intakes????

SO I want to run my air filters right off my carbs and get rid of all the extra shit in there, filters are the same O.D. as the carb inlets, where can I get filters to fit????

well done on the bike dude, how long did the build take?