SoulMan's latest activity

Well I looked at the service manual and found the xs400g in there. I think I have the wiring sorted out one of the turn signal...

I'm a little bit lost in the sauce trying to connect the front end electrical. Obviously some of the connections are well ..... obvious...

Yeah I saw online that said that was a part that's hard to find. So I was planning on finding my round file and just just clearing off...

Can I reuse that bushing after I make sure to clean off any kind of burr or whatever on that or is it meant to be a consumable?

Well I didn't realize that there was a bushing of some sort in the old bearing. shit

Well I guess it's the right outer diameter just not the right inner diameter. I was able to get it out just fine with the blind bearing...

I'm screwed... This is the axle bolt in the center of this bearing Iit sn't the right bearing. Unfortunately I didn't compare the...

So. Installing the rear bearings. The non chain side went inike butter. I heated the hub and had the bearing frozen. Went to do the...

And on that note, do you happen to have any suggestions for like a new protective wrapping? I don't even know what it's called to put...

This morning I swapped the stator from the 2nd bike to my bike because the wires coming out of it were better and I'm it was able to...

I still had to get it started with a punch but after making a little bit of space between the bearing and the bearing spacer this made...

And just a note for myself after the cut. It's about an extra 25 in of wire until the terminals are there and it's about 30 in total if...

When I saw the left hand controls I thought there has to be something wrong with this. This doesn't look right cuz it look like some...

While I'm waiting for some parts, I'm looking at other things that I know are going to need to be done and check out what I found with...

I was planning on installing these all balls bearings I purchased but now I am on the fence and considering trying to use better...

This is awesome and a great idea.

FYI I also used it to clean inside the wheel hub where the bearings etc go and it worked great :)

I am planning to pull the parts from the brake hub and clean them along with the bearings and seals from the rear. I will freeze the...

I figured out that spacer and the spacer flange... I thought it was one part before but its actually two parts and the flange just keeps...

I got the dust seal sorted out. I had to hammer the bearing off and repair the little seal that comes with the tapered bearing and then...

I know these aren't the default handlebars but I'm just going to roll with them for now

Well I ended up going ahead and doing the install because it does look like that's supposed to be there

Okay, I was able to get the lower bearing race off the bottom of the stem. Is this what appears to be a plastic ring supposed to be at...

I think I was able to clean out the bottom of the fork tube where the copper washer seals the bottom. Regarding the steering stem lower...

Nice!

Yeah the cleaning actually went really really quick with those. I did use dish soap to break out some of the gunk but I rinsed it out...

Actually I wasn't logged which is why the images weren't working when I tried to post them. Here they are. Wife was busy painting so...