Search results

Hey there . I have a 400e . Checking the points and have run into some issues . I’ve seen all the videos on setting timing for these but this seems different . The pic has the engine set to LF . But the points don’t make contact . Contact is actually where the blue line is so I can’t make an...

I have a pair with of bs34 for an 81? I could sell them to you with all the parts so you have spares

Hey there so I recently disassembled the rear wheel to replace the bearings. I Reassembled everything but this doesn’t seem quite right . Are the dampers supposed to slide into the sprocket slots ? I don’t think I put it on backward. manual says something about milled flat surfaces on crushed...

Hey there so I recently disassembled the rear wheel to replace the bearings. I Reassembled everything but this doesn’t seem quite right . Are the dampers supposed to slide into the sprocket slots ? I don’t think I put it on backward. manual says something about milled flat surfaces on crushed...

Yes I have 2 . If you’d like I’ll take pictures of the both of them today . One is a slightly different one probably from a 650 but it fits I believe

Any advice on how i should try and mount these?

Looks like they got grinded off. And theyre on these weird mounts that a cirlce was grinded out of . Any idea what the previous owner was thinking with these?

Hey there, my bike came in parts and now that I'm mounting the ignition coils its not clear from any manual or pictures i could dig up how theyre suppose to mount onto the frame. Any one have any pics of theres? I have a 78 sohc if that chanmges anything

sorry SOHC

Hey there. I have 2 engines that I'm looking to get rid of. 1 has almost all parts but is in pieces at the moment and dirty. The other is missing pistons and has a hole in the crankcase. Transmission cam and crank seem good and i have all the covers. Let me know what your interested in and...

Hey there , I’m going back and working on these carbs. They’re for a 650 but I have the brackets for the 400. Only issue is the shafts need to move about 6 -8mm . I think I’ve got 3 options to get these to work. 1. cut away these red areas . Only issue is the piece may not be strong enough...

What would be the issue with these triples? Would the standard bearing races not fit ? the 400 triples are on my frame and torqued so i dont want to take it off to check

It’s about the journey not the destination Chris.

I should really just buy a 650 at this point . Got these 650 I assume triples that have room for 35mm forks . would these fit a 400 frame?

Are the stock ones i have fine or is it too much pitting? I can just throw some gaiters on top

I took it apart for cleaning and inspection and to paint the frame. The bushings look good so I'm just going to resuse them. I must have lost track of where the shims went I'll look but i don't remember seeing a shim that was as wide as the parts on the cmsnl list.

Hey there , Does anyone have the thickness of the swing arm shins. Labelled 4 in the parts diagram . I fitted it without them and there’s the smallest bit of play . I searched through and could only find Chris saying they’re “paper thin”. I might need to find replacements. I have some that are...

So the stock forks i have look to be suffering from some really bad rust pitting above the oil seals. I'm assuming this will cause some leaks but they're only sparse except for below where the steering head mounts. Is it possible to fit what i assume is xs650 forks on (35mm in diameter vs 33mm...

So I finally finished my engine using parts from the two better looking engines . I basically bought some guys garage worth of stuff which is why I have 3 engines and random 650 carbs. I decided to check out the 3rd engine just to see if I could maybe part it out or if there were things worth...