1" Handlebar Risers

brownie44

XS400 Enthusiast
Messages
39
Reaction score
0
Points
6
Location
God's Country
i picked up a set of 1" diameter apes for dirt cheap. i know my stock risers are 7/8. anyone know where i can get 1" risers? i looked on ebay but none of those look like they'll work. i'm positive this has been done before, can someone point me in the right direction?
 
Reviving this thread because I want to install micro switches inside the bars. 1" bars would give me a little more wiggle room to work with the wiring and whatnot. I found some super cheap 12mm LED switches on amazon and ebay but dimensions are right at the limits for a 7/8" bar. LED would replace the turn signal indicator and allow me to remove the indicator lights as well.
 
Any local Harley shops around you may have a used parts pile where you can find old risers and adapt them to your triples (maybe not tell them you're putting them on an import bike -they used be grumpy about that in the past). Failing that you could source some from ebay. Shouldn't be too hard though. Good luck!
 
Back
Top