Rocker arm adjustment plugs.

MrStubb

XS400 Addict
Messages
455
Reaction score
17
Points
18
Location
Princeton Minnesota
Started to try adjusting valve clearance and discovered %&&$#%@&&^% Epoxy holding one access plugs in. Didn't go any further than that. Does anyone have a set to sell?? Threads in the cam cover seem good just the threads on the plug. Almost looks like they were machined off. Must have started with a cross thread . Also looks to be a freeze plug on the bottom of the block where there's a small oil leak. Any ideas what it's for and can it be replaced? Bike is an SOHC 80 XS 400 G
:banghead::yikes:
 
that "freeze plug" is a plug with an O ring on it.
It is an interference fit. getting it out can be an issue.

sounds like the inspection cap was over tighten and snapped the weakest part (next to the cover) sane thing on the tracker. I just got new ones off eBay
 
Back
Top