Recent content by delma

Thanks for the reply BBS! A quick update, after getting it back on it worked great for about 10 or 12 cranks, then back to its old tricks. :shrug: At this point, no clues. Thinking a new sprocket is in order.

Yes, woodruff key is still in. I’m actually sitting here now reinstalling the flywheel. I did a recheck of everything, made sure there was no obvious wear on the sprocket, etc. Just got the flywheel back on, after fighting the key, and about to torque it down again. All looks good from what...

I recently replaced my starter clutch, the original one was making the tell-tale grinding, rattling noise when hitting the start button and not grabbing the drive shaft. Yet, after replacing with brand new springs, caps and pawls, purchased from Yambits here...

That's kind of my predicament. I am in the middle of redoing the wiring harness with the munit and during a down time waiting on parts to arrive I decided to replace the clutch. So I can't really see if I can fire up the motor until the wiring is all done. Getting close though. I am going...

I've read so many horror stories about how this can go terribly wrong I handled this like it was nitro glycerin, that's why I felt the need to post this. I followed some of the tips here and after about a dozen tries I thought I had finally succeeded, but definitely wanted to verify. Good luck...

Seems mine is engaging around the same point, about halfway through the stroke and the gear sliding on the shaft without problem. Thanks Mike that helps.

Yeah, understood, that's why I only pushed it down slowly with my hand. Appreciate the input, I'll close it up and hope for the best. Thanks

Thanks Pete, appreciate the heads up, looks like I got it fixed.

Hello forum, this is my first post here, been lurking in the shadows for some time now, reading, learning, ingesting and digesting all the knowledge. First, I have to say thank you to all who have posted and answered the myriad of topics, it's been a real treat to have practically all the...