Recent content by lude

the pilots are brand new, and the fuel filter is clean and new,

so my bike will start first kick when its very old, idles great, smooth and clean sounding, however when i go to take off i have a big dead spot in the first bit of my throttle, sometimes it spits and pops and seems to have gotten worse as the weather got colder, i tried messing with the idle...

these work on our bikes if you wanna wire them in, you can get a dash for them too with lights, just something to consider, if i go tracker its what im doing,

if you have an 80, you have a sohc, dohc came along in 82,

better power delivery, sometimes a bit more power altogether, can get vm parts almost anywhere and they didnt change them every year so that right there beats bs'. and in the long run, no diaphragms to wear out, no butterfly shafts right down the middle of the bore for restrictions, and cost, a...

from what i learned from lots of reading is, they will work, but your gonna spend alot of money on jets, have 5 things in these carbs to change, and no real baseline, so its alot of guess work, i would go vm30s though. and buy them not in a kit, you can get vm30s brand new for about 66 bucks if...

what did it take to get them to fit? how much was the spacing off?

yes i have, and there was many from dohc 400s, and none for my year, untill a day or so ago a couple poped up, so i picked one up, still considering the vms, but also considering keeping the bs' who knows,

i hear that.. this is what mine looked like when i got it and after spending 20 minutes with a soldering iron and a new box,

i'm looking into running twin vm34s, or maybe even 32s, just wondering if its been done, i searched this site as well as google and not much to find. looking for a base line for jetting, and if anyone can for see any issues. top mounting cables should fit, and small air filters should fit...

looking for 75 for all if it, will take a picture when i get a chance

i got a set of parts carbs that came with them, they are in good shape, include everything including the needle. looking for 65 shipped

its been done, not my bike

thanks guys for actually putting some effort into looking for me, alot of forums wouldnt do that, that one for 35 i would pay, but sirius has the full carb kit for 32, with the tube, but out of stock, said to be back in stock in a month, might turn my attention to other things and hope they get...

i didnt break the tube, it was broken in the carb already, the brass just gets brittle, and i have no doubt the tubes from mikes will fit, im just wondering if they will work right, stock on my bike is X-6, they are Y-0, if they were the same, i would assume they would have the same...