Recent content by response

Yes. Mint now. Thanks

Yes, each of the main jets in the float bowl, plus set the other things i said too.

Yes, the Ram air are ok. But I made my own, as it was cheeper... No! not the pilot jet. Just one of the main jets that sits in the float bowl. The brass 10mm that that sits under the the bottom of the float bowl, undo that, and it sits in there. :)

Sorry, forgot to say, increase your float hight to 27.5mm Cheers

Hi Yes it does. I made my filters from some filter foam. I bought some cheap 42mm rubber to fit over the intakes, then made my own this way. Dont buy cones, as they will affect the performance of the air that enters the carbs. Yes, 135, and NRP carbs do them. You will need to balance the...

item number: 171278476259 im in Staffordshire :)

135 jet. I made my own filters. Get the jets from NRP carbs. Mine runs mint with these settings. If you take a look on Eaby, you will see my bike. I am happy to talk it through with you, let me know, and I will send you my number. :)

Yes I do, mine is finished. Where are you based? you can call me if it helps, quite a lot to explain...

HELP! Does anyone know where I can get a repair kit for my rear master cylinder?

no yet. but i will install some, before i start. I have re jetted and i will be running cones

Hi I have fitted new carb mounts. To be honest, i was doing the throttle same time as choke. next time, i will try with just the choke. i am going to sync the carbs first, as i noticed when she was running, the pressure diffrence felt at the exhaust was a lot diffrent from one side to the other.

Yes i have tried the choke too... yes i did twist the throttle... but nothing, until I put my hand over each inlet, while cranking, then we are off and running...

Hi People... I know I dont have an XS400, but I do have a XS250.... really need some advice I have just stripped and cleaned my XS250 CVH carbs, it runs ok, once i get her running, but if i leave her over night, I struggle to start her, unless I pop my hand over each carb inlet, turn it...