Recent content by NTOLERANSE

looking for a replacement engine for my sons 400 maxim. I bought his bike several years ago needing a head gasket. I replaced the gasket but struggled with the carbs and timing. Sent the bike to a guy I had dealt with before. My son was 15 then. He's a freshman I college now. I just got the...

Hard to do that from a phone. :(. I'll try

I need the part number for the half moon shaped seals that go near the end of the cama on the cam cover. Any help?

Old thread...wow

I am looking for the four little exhaust collars that go around the pipes so the flanges can hold the pipes to the engine. They are little half circle shaped pieces. I have three, missin one. Also looking for the two side panels that connect the tank to the rear fender. Look at he pic, youll...

Looking for the body side covers that connected the tank to the rear fender. I need both sides. See pic, youll see the maroon section thats missing

Where do these go? They are threaded.

Wondered what that was for. Wish i had taken this apart

Here is a pic of the cam marks. Ready to button it up. What do you all think?

That was the way I. Got them to line up, perpendicular to the crank centerline, so is the manual incorrect? I don't have it fullly assembled but it seems to have compression

Ok, I cannot get he cams timed. I have the serv manual d/l form this site, pulled the cam chains adjuster out, but cannot get the cams lined up with the crank mark. Whats the secret?

Looks like i am missing both side covers/trim. Also i am missing on of the exhaust collars (in pic) Where do the other two piece go in the attached pic? Does the engine need to be raised up to get the upper mount bolts to line up?

Thanks Dave

Couple of questions..... Does the front cam chain slider just drop in. On the right side of the engine the two big head bolts have a copper type washer, but left left side doesnt. And are these the right nuts for the head studs? This thing was apart when i got it so i dont have the...

Started cleaning parts for reassembly. What are he little o rings for under the bores between the bores and the cylinder case? I have new rings, just dont understand what they are sealing?