Search results

welcome to the forum hmusket, The flasher relay is located under the seat above the carbarators. should be a smaller rectangular box with a three prong terminal on it. If that checks out ok i would suggest tracing the power wires on each of the turn signals back to there power source.

Wow that makes sense! I swear when you concentrate so much on one thing you tend to over look something like that. Thank you very much. For a lil while I was beginning to think I was the only person to ever has this happen to them. Lol. I will try that tomorrow for sure or find a better ground...

Great minds think alike! I have indeed. it was what I thought was the original fault wheIi got it apart I saw that a solder joint had popped off and upon further inspection I found that the little black plastic piece that has the 3 terminals was in fact broken hence the solder point popping off...

Hello everybody names Dan still kinda new here mainly been reading previouse threads and learning about my bike. I got a 1980 xs400 special from a buddy of mine for $100. it didnt take much to get her running but it has been hair pulling getting it to a good overall working condition . I ll post...

sounds good. thanks you very much. for the past couple of days all i have been doing is wiring. I believe i just needed an outside source for a change ya know? again thank you

Its just the running light the brake light (front & rear) both come on when used. i used the jumper on the relay under the front of the gas tank. doing that i was able to have a headlight but there was still no running light on the tail light. i just built a new fuse panel bc the old one was...

Hello everybody names Dan still kinda new here mainly been reading previouse threads and learning about my bike. I got a 1980 xs400 special from a buddy of mine for $100. it didnt take much to get her running but it has been hair pulling getting it to a good overall working condition . I ll post...

I had the same issue but switched. I found that when i took apart the turn swith assembley there was a wire that came disconnected from under the switch selector. i just re-soldered it and it was good as new.