Normand
XS400 Member
Hi, i started a xs360 project 1 month ago. You can find my first topic in the non-xs400 thread.
My bike didnt run for 30 years
Actually, my engine start and run good on the idle (around 1200 rpm)
BUT, as soon i get over 2000 rpm, it stall. The bike can run with choke open, it go close to 2000 and cant get more.
I am not sure if its caused by electricity problem, too much air flow cause i removed my air filter, or a jet problem.
New plugs, cables, new oil, new battery, my alternator dont charge cause of my rectifier,i just bought a new one on ebay and still waiting for it)
I partially cleaned my carbureators, i opened them but i didnt removed the jets. Top and bottom opened, i sunk everything into pinesol...
I removed the air filter for cleaning and didnt put it back because its too dirty and old.
Then, after all this, my engine start and run very well on the idle..
I just ajusted the floats but didnt tested.
Sorry for all mistakes i made, i dont speak english very well.
Thank!
My bike didnt run for 30 years
Actually, my engine start and run good on the idle (around 1200 rpm)
BUT, as soon i get over 2000 rpm, it stall. The bike can run with choke open, it go close to 2000 and cant get more.
I am not sure if its caused by electricity problem, too much air flow cause i removed my air filter, or a jet problem.
New plugs, cables, new oil, new battery, my alternator dont charge cause of my rectifier,i just bought a new one on ebay and still waiting for it)
I partially cleaned my carbureators, i opened them but i didnt removed the jets. Top and bottom opened, i sunk everything into pinesol...
I removed the air filter for cleaning and didnt put it back because its too dirty and old.
Then, after all this, my engine start and run very well on the idle..
I just ajusted the floats but didnt tested.
Sorry for all mistakes i made, i dont speak english very well.
Thank!