Recent content by phil63146

Thank you

Repairs are better for the pocketbook and I prefer repair whenever practical. But when a box of electronics approaches 30 years of road use I get nervous about it's integrity. Thanks for the tip about Rex. Does he have a website or address I can contact him? Phil

Has anyone used this product? I came across an aftermarket supplier of TCI and CDI ignition box. Their name is IgniTech from the Czech Republic. They list a replacement for the XS400 ignitor called the Sparker TCI. They can be found at ignitech.cz and don't forget to click on the Union Jack...

thank you

bump it up again

If the numbers match the one in my photo and have no rust or mud on the circuit board, you bet. Let me know. Thanks, Phil

let's try again

try this and good luck http://www.jcwhitney.com/jcwhitney/textsearch_result.jcw?sku=seat+cover&shopid=100003&_requestid=8128534

Looking to buy dead 12R-10 boxes for $15 each (after passing inspection). Must have had a dry life. Boxes with rusty/muddy circuit board or electrical plugs not wanted (remove the 4 screws to view the bottom of the circuit board). There are a lot of them out there but more and more are dying. I...

Thanks so much.

All I know is I have a stock bike. I just ordered an electronic tach and was hoping to make some comparisons. Thanks anyway.

Approximately a lot is a given. I was hoping for a real world answer.

I have an '82 XS400RJ SECA 6 speed. Can anybody tell me the RPM at 40,50,60,70 MPH while cruising in 6th gear on a level surface? Thanks. Phil

Hardly. That is what the factory manual says.

standard 142.2 max156.4 min 113.8 both plugs out, throttle wide open.