Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Enjoy XS400.com?Consider making a donation to help support the site. XS400.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
yea i would like to remove the extra two bars and leave the single main backbone but also adding gussests. was checking to see if anyone else had tried this?
would it be possible to trim off the two side back bones and just have the single main backbone? would it need gussets? so mounting different tanks will be easier? i have seen a few builds do it but they were all going to a hard tail. i would keep it a soft tail.
mine are 2 into 1 home made by the po who wrapped them, to put it nicely they look like junk and look like a cob job. i would like 2 into 2 mufflers and i want a nice clean looking bike
Ruined1
-my stock orignal flasher relay does not work, however when the bike is on & also the turn signal, i can tab the relay & make turn signals lights flash. thats why i am asking about the flasher relay.
Frwinks
- do you have any photos of what you did to get the relay to work?
ok so i have led front and rear turn signals on my 1980 bike. will the Tridon EP34 flasher relay work for this application? i really dont wanna mess around with resistors.