Search results

  1. downtimeinc

    Wanted - center stand, rear fender lower, front brake handle/mc,

    Hi Guys - lookin for a few parts...need a center stand, a rear fender lower (plastic section that sits behind the engine, and a front brake handle with master cylinder. Let me know if you have all or any - Thanks!
  2. downtimeinc

    busted bleeder valve off - ideas?

    Hey guys - finally got my 79 up and running and just about finished...was in the final stages of adding fluids etc when i managed to sheer off the bleeder valve on my rear disc brake. I hit it up with pb blaster then tried to get it with a grabit - 3 sizes and a broken off in the hole bit and i...
  3. downtimeinc

    Wanted - 79 rear brake caliper

    Hi Guys - had everything pretty much ready to go and managed to shear off the bleeder valve on my 79 rear caliper while trying to bleed the brakes - looking for a replacement...Thanks!
  4. downtimeinc

    79 rear axle spacer question

    Hey Guys - I've finally gotten around to reassembly, and after sending out the rear wheel for new rubber and beginning to put it back together I realized that I've misplaced my rear axle spacer somewhere...torn apart the garage 3 times so far but no dice. Does anyone know if there's another...
  5. downtimeinc

    Wanted - 79 rear axle spacer

    Finally at reassembly stage and can't for the life of me find my rear axle spacer. If anyone has one for a 79 (has the rear disc brake) I would love to hear from you - Thanks!:thumbsup:
  6. downtimeinc

    Wanted - header studs, front fender, clutch lever, turn signal switch etc

    Hey Guys - I just picked up a 79 xs400 which is in need of a few parts...looking for the following if anyone has 'em: left side switches for turn signal/light controls headlight front fender clutch lever (with bar clamp) clutch cable, tach cable, speedo cable rear disc brake line chain...
  7. downtimeinc

    broken header bolt & muffler cut off question

    Hi Guys - I'm relatively new here and hoping someone can point me in the right direction...I'm in the process of installing some 16" shorty slashcuts on an 82 exhaust. While loosening the header bolts i managed to break one off - its not sheared, but busted off at the nut. Am I correct in...
  8. downtimeinc

    Hello from another Canadian (cafe-bobber projects)

    Hey Guys - just wanted to say hello...been lurking on here for awhile now and have picked up some great info - thanks! I've been working on an 82 xs400 special cafe project for a little bit, and am now waiting on some parts to show up after a little incident with my wife and our truck...on the...
Back
Top