tbakic
1st cafe project underway
so my bike wouldnt start, suprise. I checked everything, (only one plug was getting wet)pulled carbs, they were pretty dirty so i ripped them all apart and cleaned them and saw my pilot jet was clogged on the side with the dry plug i soaked all jets in carb cleaner and cleaned out every hole and passage way. I put them back together but i have some questions...my carbs look slightly different thank most i have seen on here, and my jet sizes are different than any ive seen too...
heres what my carbs look like
i put all the jets back in and everything
i dont remember one of my jet sizes but my pilot was 42.5 and this one(i believe main, it screws in here with the washer)
was a 155??!!!
can that be right?
next im not sure "how to adjust the carb height, do i bend the small tab that the needle slides on to? or
lastly, im pretty sure these two screws on top are the air/idle mixture screws(not sure what they are called)
i set them to 3.5 turns out from snug
ive been searching the forums and i am still unclear on some these things, thanks so much guys!!!!
heres what my carbs look like
i put all the jets back in and everything
i dont remember one of my jet sizes but my pilot was 42.5 and this one(i believe main, it screws in here with the washer)
was a 155??!!!
can that be right?
next im not sure "how to adjust the carb height, do i bend the small tab that the needle slides on to? or
lastly, im pretty sure these two screws on top are the air/idle mixture screws(not sure what they are called)
i set them to 3.5 turns out from snug
ive been searching the forums and i am still unclear on some these things, thanks so much guys!!!!