-
Enjoy XS400.com? Consider making a donation to help support the site.
XS400.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
Need a source for this....
- Thread starter Flexeril
- Start date
-
- Tags
- restoration
Charles
XS400 Addict
That would be the connector for the pickup coil
http://www.boats.net/parts/search/Yamaha/Motorcycle/1982/XS400SJ/PICKUP COIL - GOVERNOR/parts.html
Unless it's bad, there's no reason to replace the whole assembly. The connector isn't sold by itself. I'd cut the connector off, solder/crimp on some water resistant spade connectors and be done with it.
http://www.boats.net/parts/search/Yamaha/Motorcycle/1982/XS400SJ/PICKUP COIL - GOVERNOR/parts.html
Unless it's bad, there's no reason to replace the whole assembly. The connector isn't sold by itself. I'd cut the connector off, solder/crimp on some water resistant spade connectors and be done with it.
Better yet RadioShack sells block connectors similar to that (they are more universal so you may have to put one on both sides). I use them when changing things on the harness for they seem more permanent/professional and they are just as easy to attach but then again spade connectors are also good
danisawesome
XS400 Addict
Eh, probably a better idea to fix it once the right way. There are a bunch of connectors listed on MikesXS near the bottom of the wire terminals and connectors list:
http://www.mikesxs.net/products-78.html#products
Charles
XS400 Addict
Keep in mind, when you get a connector like this:
http://www.mikesxs.net/product/12-0634.html
You need to have the proper crimping tool for the barrel connectors that come with it. This is what you want:
http://www.mikesxs.net/product/35-0008.html
I know you want to keep it stock looking, but if you're only replacing one connector, it doesn't seem worth it.
Like I said before, I'd cut off the broken one, crimp on male spade connectors with the flexible plastic covers. Like this:
http://www.mikesxs.net/product/12-0020.html
Then connect them to the intact female connector. That will look almost exactly stock and be MUCH cheaper.
http://www.mikesxs.net/product/12-0634.html
You need to have the proper crimping tool for the barrel connectors that come with it. This is what you want:
http://www.mikesxs.net/product/35-0008.html
I know you want to keep it stock looking, but if you're only replacing one connector, it doesn't seem worth it.
Like I said before, I'd cut off the broken one, crimp on male spade connectors with the flexible plastic covers. Like this:
http://www.mikesxs.net/product/12-0020.html
Then connect them to the intact female connector. That will look almost exactly stock and be MUCH cheaper.
you can unhook the barbs in the connector and reuse them if they are good.
new mini block connectors should be easy to find only, especially via ebay
http://www.vehicle-wiring-products.eu/VWP-onlinestore/connectors/multiconnectors.php
new mini block connectors should be easy to find only, especially via ebay
http://www.vehicle-wiring-products.eu/VWP-onlinestore/connectors/multiconnectors.php
Charles
XS400 Addict
That too! Usually you can slip a small flathead into the connector and free up the spade terminal, then pull it out.
