bcXS400-81
XS400 Enthusiast
Hey gents,
Just took apart my front end to install clip-ons and noticed my right front fork is bent where it clamps to the lower tree. I put it up against a straight edge and it deviates about an inch at the bottom of the fork . I have another '81 with disk and mags, so I was thinking I would just swap out the right side fork with the bent one (provided it's straight...).
Will this work? I know the caliper mount will be a bit of an eyesore. I may also just replace the stanchion with a straight one.
Just took apart my front end to install clip-ons and noticed my right front fork is bent where it clamps to the lower tree. I put it up against a straight edge and it deviates about an inch at the bottom of the fork . I have another '81 with disk and mags, so I was thinking I would just swap out the right side fork with the bent one (provided it's straight...).
Will this work? I know the caliper mount will be a bit of an eyesore. I may also just replace the stanchion with a straight one.