Builtin_DaShed
XS400 Enthusiast
My carbs were disassembled when I brought the bike home, guy I got it from started to clean them and didn't finish.
I've started going over them to see what's what.
Going to have to get a carb kit, holders, plugs etc.
Anyhow when going over the carbs schematic from Yamaha I noticed some missing pieces.
There are two small ball bearings for the choke rod spring detent missing.
Yamaha p# 93501-08001-00 BALL says 1/8" diameter, I measured the hole they go in on carb comes out to .124 close enough, now I do have a bunch of miscelanious bearings in the shop that I can make work they measure .120+/-.
Can someone measure a ball please?, if they have one around.
I just want a comparison for slide fit and to see if I can reuse something not originally intended for this purpose which I love doing and not have to buy if I already have it.
thanks for the help.
I've started going over them to see what's what.
Going to have to get a carb kit, holders, plugs etc.
Anyhow when going over the carbs schematic from Yamaha I noticed some missing pieces.
There are two small ball bearings for the choke rod spring detent missing.
Yamaha p# 93501-08001-00 BALL says 1/8" diameter, I measured the hole they go in on carb comes out to .124 close enough, now I do have a bunch of miscelanious bearings in the shop that I can make work they measure .120+/-.
Can someone measure a ball please?, if they have one around.
I just want a comparison for slide fit and to see if I can reuse something not originally intended for this purpose which I love doing and not have to buy if I already have it.
thanks for the help.
Last edited: