jmd_forest
Bldg 1980 XS400 Cafe Bike
We just received a pair of 0 Ohm plug caps from ebay and I plan to install a set of Iridium BPR7EIX plugs. Any suggestions on gapping the plugs? Standard for BP7ES is .7 to .8 mm.
-
Enjoy XS400.com? Consider making a donation to help support the site.
XS400.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
Gapping Iridium Plugs
- Thread starter jmd_forest
- Start date
i use standard setting
NGK plugs tend to be well gapped from the factory. I always double-check before I install them, however. I consistently get a 0.711 mm measurement with a feeler gauge.
If you do have to gap an iridium plug just be EXTRA careful not to touch the fine tip. The disc-type gapping tools are no good for this kind of plug. You want to pry on the ground strap alone.
If you do have to gap an iridium plug just be EXTRA careful not to touch the fine tip. The disc-type gapping tools are no good for this kind of plug. You want to pry on the ground strap alone.
