It's runniiiiiiing!!! Suuuper stoked. I took the right side handlebar switch apart again, cleaned and pulled blue/white that went to the button out of the housing, re-attached housing after making sure it could ground well. Connected blue/white where it was cut which was starter button and after reconnecting the red/white together on harness I touched the button to the bars and it turned over. Brown is just hanging as is red/yellow which is headlights. I almost wonder if all those went to a terminal plug that was cut out. Went straight to checking for spark, big fat blue spark on right cylinder, then same on left. Mounted gaskets, intake boots, carbs and h-pipe, fed a little gas and she started up, smokin like crazy but it's running! Tank was already cleaned and ready but my petcock flows hard on prime, drips steadily on reserve or on. I cleaned and routed throttle cable when I had that open so it's ready to be attached to carb. Time to do some research on those carbs, settings and check float height. Will clean air boxes well and mount, I was surprise to see filters in there and in good shape. I'll start searching but any info on that stuff would be awesome. I also need to look into fuel line routing and what to do on those intake boot ports.