I'll post up on CF in a little bit... Thanks everyone!
Here's the support I welded on for the hump. I just measured it all out and the seat rests perfectly on it
Here's the tail light on without brakes... the light in the garage kinda drowns it out but it's definitely bright enough
and here it is with the brakes applied... by the way the clear portion is not blacked out.
Here is how I mounted the seat... I welded in a piece of steel between the frame and it bolts right to it. The piece also supports the seat...
and then I made a piece out of the jacket using the buttons on the jacket to hide the screws... Im sure it could be done better but I really like the look of the jacket and using different parts of it to make it all come together
This is how I lowered the headlight... just a small bracket out of some sheet metal
I also lowered the speedo and tach.. the bracket sits on top and has bolts welded to it. I cut those bolts out and mounted the bracket below where it normally mounts and used a 1.25" round spacer. The new bolt runs through the spacer... Sounds confusing but hopefully the pic helps...
I also decided the foam I used originally wasn't what I wanted to I pulled the leather back and put in 2 layers of high density foam.. so much better.