I had finished all of the valve adjustments I had the carbs bench adjusted, I filled it with fresh oil and attempted to start my 1980 G. It crank over a few times and the battery went dead from sitting. I recharged the battery and attempted to start. The motor cranked over a few times, then made a rattling noise and wouldn't turn over after that. Pushing the starter switch would activate the solenoid but not turn over the bike. I attempted to kick the bike over and it would not let me kick through, very much like when you have the kick starter installed it properly. I know that is not the case as I have kicked it through several times. I recently had the starter clutch out and cleaned that up and it was working fine to crank. My initial reaction is to check there first, to make sure everything was reinstalled properly. Any thoughts are welcome.