I think the clip position I had the needle at originally was stock (4th position down counting from the top). Currently it is at the 3rd position.
I was going to try a 140 main, but I will need to order it. I have everything from 142.5 to 160, but I am missing a lot of the smaller sizes...
I just adjusted the float needles to open a bit more when the floats fall. I reset the float height to 26 mm. I will give this a try tomorrow to see if it has any effect.
I was going to try a 140 main, but I will need to order it. I have everything from 142.5 to 160, but I am missing a lot of the smaller sizes...
I just adjusted the float needles to open a bit more when the floats fall. I reset the float height to 26 mm. I will give this a try tomorrow to see if it has any effect.