I had to remove the side cover to reinstall starter.
Harness being placed back into bike. Notice that I used some harness wrap and tie wraps rather then electric tape. Harnesses are not wrapped in electr
Harness back in bike. I found it easiest to completely remove the battery holder and disconnect the rear shocks. This gave me more room to route the h
Starter with the new larger gauge wire.
I had to remove the side cover to reinstall starter.
Bullet connections with clear heat shrink on them.
Part of cooked harness
Inside the Ignition. The harness burned up into the ignition so I had to replace the wires and re solder the connections.
gbyamaha

I had to remove the side cover to reinstall starter.

There are no comments to display.

Media information

Album
1979 xs400 (xs250) harness rebuild
Added by
gbyamaha
Date added
View count
1,255
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top