the front end is all put together, torqued and set just as the manual says. I ave the front tire off the ground and when the steering is centered i ca
little bit of a wide bike but it lets you know there is room for sattle bags!
tail lights are on and i have an evtension piece of wire that runs in the fender to the wire harness.
I put all of the controlls back together and started to see how to route everything. I noticed that it has 21977 on it and if i can get it to roll out
the front end is all put together, torqued and set just as the manual says. I ave the front tire off the ground and when the steering is centered i ca
one carb was alot dirtier than the other, which is normal. I will be replacing parts needed to rejet and recalibrate. When the carbs finish boiling al
i seperated parts as they would have to get bagged and labelled once they were cleaned, the bad wold have to have a good seal or they may as well be c
I took both carbs completley apart and seperated metal that i can clean with carb cleaner and what I can boil, and what will have to be cleaned with o
TimmyT

the front end is all put together, torqued and set just as the manual says. I ave the front tire off the ground and when the steering is centered i ca

There are no comments to display.

Media information

Album
1978 Yamaha XS400
Added by
TimmyT
Date added
View count
2,182
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top