The T50 staples I used as an extraction tool.
Bullet connections with clear heat shrink on them.
Part of cooked harness
Inside the Ignition. The harness burned up into the ignition so I had to replace the wires and re solder the connections.
The T50 staples I used as an extraction tool.
The Amp/Tyco sockets I used
2. Mark each connector with a number to identify it. Mark the board with a line to indicate the branch length. On your schematic, indicate the connect
New starter cables. I used some epoxy and mil spec lugs from work.
gbyamaha

The T50 staples I used as an extraction tool.

There are no comments to display.

Media information

Album
1979 xs400 (xs250) harness rebuild
Added by
gbyamaha
Date added
View count
1,223
Comment count
0
Rating
0.00 star(s) 0 ratings

Share this media

Back
Top