I'll look into the reservoir cost if this works out. They have to be cast to be watertight and resistant to brake fluid.
Really should have a vacuum chamber to cast them properly too.
I'm going to setup a mould of the velocity stack and try them both at the same time.
The fuse holder printed part works as-is and can be ordered online. I believe the print is less than $10 plus shipping.
The individual fuse holders have to be ordered separately and there is some assembly required to connect to the harness.
Still not 100% confident in the solder handling long-term vibration from the bike.
Really should have a vacuum chamber to cast them properly too.
I'm going to setup a mould of the velocity stack and try them both at the same time.
The fuse holder printed part works as-is and can be ordered online. I believe the print is less than $10 plus shipping.
The individual fuse holders have to be ordered separately and there is some assembly required to connect to the harness.
Still not 100% confident in the solder handling long-term vibration from the bike.