Bellerophon
XS400 Member
Following on from my sandblasting fiasco, I am doing as much of a deep clean as I can including washing out all the oil feeds. With that in mind, what is this in the attached pic and should I be able to get it out? I can lift it by about 5mm but then it stops dead.
My guess is that it's a flow restrictor so the shaft doesn't get flooded by oil. Ideally I'd like to be able to remove it so I clean its tubes.
My guess is that it's a flow restrictor so the shaft doesn't get flooded by oil. Ideally I'd like to be able to remove it so I clean its tubes.