ok, so I reset my float heights to 26 mm and tried it again. It is still doing the same thing. took out my plugs and the right side is carbon covered and the left is basically dry with no residue. the bike will start and low idle but chokes out. Last night i rode it home after warming it up and could only max out in 2nd gear. Downhill it was fine. but up hill top of second was maxxing it out. it has no power and i'm assuming the left side isn't firing. any ideas would be super appreciated! thank you. I recently put a new float in and made sure that just as it touched my jet it was 26mm. both sides but one side has an old float in it. i checked the compression on both sides with my thumb while turning it over and it seemed about equal, although it was not enough to blow my thumbs off. I am struggling to figure this out. grrrrr.