I'm having the same problem as goutes2006 with the high idle. Rather than hijack his thread I thought I'd start this one.
There are small cracks in the plastic where the carbs bolt onto the engine. Is there anything I can use to seal the leaks without having to replace both parts? I thought about using some type of epoxy or liquid electrical tape but wasn't sure if this would work. Any suggestions are welcome.
Thanks
There are small cracks in the plastic where the carbs bolt onto the engine. Is there anything I can use to seal the leaks without having to replace both parts? I thought about using some type of epoxy or liquid electrical tape but wasn't sure if this would work. Any suggestions are welcome.
Thanks