xscafe
XS400 Member
First off I want to see if there are any members on here who are machinists that can resleeve my engine. If not maybe a suggestion to a place I can ship. I was looking at L.A. Sleeve but I have no experience. My machinist won't do bike engines. (I've used him for car stuff).
Second I want to see what you guys think of what I'm planning on doing. I'm planning on running XS650 liners bored to 77/78mm and raptor 250 Pistons in 10.5:1 comp. (if the starter can turn that) I'm also planning on either regrinding the cam or using a "performance" one if I can find one. I also want to go a little bigger on the valves and put new springs on.
I've done a bunch of research on the piston sleeve combo but all I've seen so far is "it should work" but nothing about it being done. Will it work? I've yet to look too far into valve train.
Thanks
Second I want to see what you guys think of what I'm planning on doing. I'm planning on running XS650 liners bored to 77/78mm and raptor 250 Pistons in 10.5:1 comp. (if the starter can turn that) I'm also planning on either regrinding the cam or using a "performance" one if I can find one. I also want to go a little bigger on the valves and put new springs on.
I've done a bunch of research on the piston sleeve combo but all I've seen so far is "it should work" but nothing about it being done. Will it work? I've yet to look too far into valve train.
Thanks