Follow along with the video below to see how to install our site as a web app on your home screen.
Note: This feature may not be available in some browsers.
Enjoy XS400.com?Consider making a donation to help support the site. XS400.com receives a small share of sales from some links on this page, but direct donations have a much greater impact on keeping this site going.
Ok after buying 3 different relays I finally got the right one today. Now the problem is all 4 blinkers flash at the same time. It doesn't matter if the switch is in the left or right position. Anyone else run into this?
One thing I forgot to mention. Before I installed the electronic relay all of the blinkers would light up solid with the factory relay and led flashers. They didn't flash.
1. Put stock flasher back on.
2. Buy four 10 watt, 10 ohm resistors (about $4)
3. Add one pair of resistors in parallel from the colored/striped wire to the ground wire on each of the rear signals. You can test the connection before permanently splicing.
4. Signal away like a maniac.
If this isn't enough resistance try a single resistor instead of a pair in parallel.