First off... sorry I just realized the picture isnt very good... But I think it has everything that I need.
So I took the starter motor apart to clean it and when I put it back together and tighten the motor case down the motor wont spin. Before I tighten it down it will spin if I am holding it with the brush side up. I am thinking in the side that has the brushes that I might be missing a spacer or something. There are 4 of them. The small one should go on the brush side and the other three there are two thin ones and one a little bit thicker. I am not sure in what order they are suppose to go on the opposite side or if the order would matter.
I worry I am missing a washer/spacer thing on the brush side because that seems to be where there is some friction is I just put the brush side of the armature into the cap there and hold it with a small amount of force with my hands I can feel the friction that would want to keep it from turning when its all tighten together. Should there be a high speed bearing grease in there like would be for brakes. I did clean the cap out and maybe cleaned it too much in that area or maybe I am just missing another small washer that goes in that area.
I see there is a washer kit 371-81809-20-00 but on ebay its quite expensive. Anyone have any thoughts?
So I took the starter motor apart to clean it and when I put it back together and tighten the motor case down the motor wont spin. Before I tighten it down it will spin if I am holding it with the brush side up. I am thinking in the side that has the brushes that I might be missing a spacer or something. There are 4 of them. The small one should go on the brush side and the other three there are two thin ones and one a little bit thicker. I am not sure in what order they are suppose to go on the opposite side or if the order would matter.
I worry I am missing a washer/spacer thing on the brush side because that seems to be where there is some friction is I just put the brush side of the armature into the cap there and hold it with a small amount of force with my hands I can feel the friction that would want to keep it from turning when its all tighten together. Should there be a high speed bearing grease in there like would be for brakes. I did clean the cap out and maybe cleaned it too much in that area or maybe I am just missing another small washer that goes in that area.
I see there is a washer kit 371-81809-20-00 but on ebay its quite expensive. Anyone have any thoughts?