Shaun Chandler
XS400 Addict
I wasn't sure where to post this as I'm not selling these right now but I thought I would post what I did and see the interest level.
I had trouble finding the locking tabs to go on my 1978 xs400 cafe build and didn't want to just drop the part being that its a safety piece. I found that they were expensive from yamaha and I have multiple builds on the go so it made sense to make them up myself being that I know cad. I had the pieces laser cut and thought I would post a picture. If there is no interest thats fine just thought I'd put it out there.
They are cut from 20 gauge 304 stainless. Hopefully my picture attaches I've never attached a pic here. I've shown them with the old and the new side by side.
Shaun
I had trouble finding the locking tabs to go on my 1978 xs400 cafe build and didn't want to just drop the part being that its a safety piece. I found that they were expensive from yamaha and I have multiple builds on the go so it made sense to make them up myself being that I know cad. I had the pieces laser cut and thought I would post a picture. If there is no interest thats fine just thought I'd put it out there.
They are cut from 20 gauge 304 stainless. Hopefully my picture attaches I've never attached a pic here. I've shown them with the old and the new side by side.
Shaun