Wiring Help TCI Ignition

[87cody]

I am working on my 81 bobber project and finally getting to the part I have been dreading since it began, the wiring. It will have only a starter, headlight and stop/tail light. Since it is a TCI bike what all do I need to wire up to make it all work. I know there is the large TCI box but also there is 2 aluminum boxed I removed from the bike one has a built in heatsink and the other is very small. Also there were several relays. I am fabricating an electronics/battery box and need to figure out what all I am going to stuff in there.

 

[drewpy]

the 2 alu boxes are the rectifier and voltage regulator. you can buy an all in one to make things easier to install.

I suggest getting the manual and check out the wiring diagram for your bike and draw up your own diagram based on what you require/using and where they are going on the bike.

Its easier to amend a few lines than cock up the actual wiring system.

I also suggest new thin wall wire and a proper crimper for Japanese spade connectors.

check out my rewire how to for pointers.

 

[87cody]

Thank you Drewpy