jonjkim12
'77 XS360 Owner
xschris:
thanks again for keeping up with all my questions. so i've researched most of what you've mentioned here, and plan to knock them out once the center stand arrives (hopefully today). BUT i dont know what/where my capacitor is nor do i know what to do with it?
this morning i checked my points and replaced my fuel filter. photos attached. one thing to note is my right point (when open) had a little thing sticking out from the center of where the contact is made, i could hear it scratching my feeler guage as i was checking the gaps. can you see it in the photo? would this cause anything? if you see anything else in those photos, please do mention.
i also checked the air pods (until i order those Unis, i dont want to order them yet because i'm not prepared to rejet once i get them) i checked the size of my air pods and the rubber that connects it to the carb said 52mm so i'm assuming thats the size i'd buy? if i buy the same size but Uni's would i need to rejett? also not sure how to clean aside from blowing compressed air at it.
also check my oil level and i'm good. gonna buy some 20-50 incase i lose some oil doing the points.
def learning a lot, thanks again for you guys' help.
thanks again for keeping up with all my questions. so i've researched most of what you've mentioned here, and plan to knock them out once the center stand arrives (hopefully today). BUT i dont know what/where my capacitor is nor do i know what to do with it?
this morning i checked my points and replaced my fuel filter. photos attached. one thing to note is my right point (when open) had a little thing sticking out from the center of where the contact is made, i could hear it scratching my feeler guage as i was checking the gaps. can you see it in the photo? would this cause anything? if you see anything else in those photos, please do mention.
i also checked the air pods (until i order those Unis, i dont want to order them yet because i'm not prepared to rejet once i get them) i checked the size of my air pods and the rubber that connects it to the carb said 52mm so i'm assuming thats the size i'd buy? if i buy the same size but Uni's would i need to rejett? also not sure how to clean aside from blowing compressed air at it.
also check my oil level and i'm good. gonna buy some 20-50 incase i lose some oil doing the points.
def learning a lot, thanks again for you guys' help.