I did a cylinder hone to polish them a touch, cleaned the carbon from the combustion chambers and piston, did a valve lap. I resealed the entire engine except I did not split the cases or remove the rocker assembly as no wear showed. I had new rings but didn't use them as the others look great and measured to spec. Basically, I bought an overhaul gasket set for $35.00 and the rings I bought for 26 dollars will go into the other motor when it gets done,So what new parts exactly did you buy for them? You just cleaned up the valves and lapped them only?
This is my first engine build in a bike......I know they are a little simpler than a car but hell its been 30 years since I rebuilt an engine and that was a VW
I also went through the carbs.. I am not so sure about "easier" than cars...most cars have a lot more room to work with. I worked in auto repair field for 20+ years and felt quite capable there....this was a learning experience. The next one will be easier.